XL Hybrid Bulkheads

The quality of tolerance and machine work is amazing like all other flm products. You can not even see the parting line between the two half’s of the differential case where the pinion gear bearings sit. I am however dissapointed with the fittment of soread moreme factory parts when installing this. I would have liked to know previously to buying that I would have to trim the factory shock towers, and the upper control arm pin hold downs do not fit anymore or even line up remotely close, I had to trim them and file them down to almost nothing to get them to fit. But worst of all the tie rod ends catch the differential case so bad they get stuck when steering hard left or right that I almost want to put the Stock plastic diff back in. But I have had to modify the shock tower and other parts that now i can’t even go back.. it is kinda disappointing even tho this part is not available anymore, if it comes back into production I just want to warn people that it’s far from perfect and certainly needs some updates to be worth buying. The quality is five stars but the fitment may be more geared towards someone who has the ability to modify there stock parts to make this part work properly.

Good quality.

Make sure you get all the screws to seperate them 😂 there's a few.

They should tell you that you have to use their drive cups! Don't forget those!

Overall good quality and competitively priced for being solid billet!

I did neeread mored to take a file to mine to break some sharp edges and remove flashing on bearing surfaces.. 🤦‍♂️

Quality should have caught that imo..

Maybe I'm being critical?

Will do business with again regardless

💯💯🏎️💨💨

Could use updating for new swaybar set, but very well made and very strong setup. 170g per bulkhead.